Identify your VW Beetle and Bus gearbox: gearbox number, swing axle or IRS and code letters
In short: Which gearbox is in your VW Beetle or Bus is revealed by the gearbox number with its code letters and a few external features: swing axle or IRS (independent rear suspension), split case or tunnel case, 2 or 3 bolts on the front gearbox mount, and guided or unguided release bearing. With that you order seals, mounts and boots that fit.
At a glance
- Difficulty: easy
- Time: approx. 15 minutes
- Fits: VW Beetle, Karmann Ghia, Thing (Type 181), VW Bus T1 and T2
- Important: gearboxes were often swapped – always check the gearbox itself, not the model year of the vehicle
What you need
- Torch, brake cleaner and a wire brush to clean up the stamped number
- Jack and axle stands to get safely under the vehicle
- For the oil level: gearbox oil drain plug key (17 mm)
Why you should know your gearbox
VW changed a lot on the Beetle and Bus gearbox over the years: case, axle type, mounts and clutch release. Seal kits, gearbox mounts, axle boots and release bearings therefore only fit the right gearbox. And because gearboxes were swapped so often, the model year of your vehicle often says little about the gearbox actually fitted.
Step by step: how to identify your gearbox
- Find the gearbox number. It is stamped into a smooth pad on the right-hand underside of the gearbox case (seen from the rear). Do not confuse it with the raised casting numbers such as 113, 002 or 091 – those are part numbers of the case.
- Read the number. Gearboxes up to 1967 have digits only. From 1967 to August 1972 two code letters come before a serial number. From August 1972 the code letters are followed by the date of manufacture: day, month and the last digit of the year – so "AS 15053" means 15 May 1973.
- Look at the rear axle. Swing axle or IRS? You can tell straight away from the axle tubes or drive shafts (table below).
- Check the case and gearbox mount. Split case or tunnel case? How many bolts does the front gearbox mount have?
- Look into the bell housing (with the engine out): if there is a guide sleeve around the input shaft, the release bearing is guided – more in our guide Guided or unguided clutch.
- Look up the code letters – in the tables further down.
The key features at a glance
| Feature | Early version | Late version | How to check |
|---|---|---|---|
| Gearbox case | split case (joint running lengthways down the middle), up to 7/1960 | one-piece tunnel case, from model year 1961 | Joint visible along the length of the gearbox? |
| Synchromesh | 1st gear not synchronised (up to 7/1960) | all forward gears synchronised (from model year 1961) | follows from the case |
| Front gearbox mount (Beetle) | 2 bolts (1961 to 7/1972) | 3 bolts (from model year 1973), front gearbox mount from 8/72 | Count the bolts on the gearbox nose cone |
| Release bearing | unguided (up to 7/1970) | guided with guide sleeve (from 8/1970) | Sleeve around the input shaft in the bell housing? |
Swing axle or IRS?
| Swing axle | IRS (double-jointed axle) | |
|---|---|---|
| How to recognise it | Axle tubes (trumpets) attach directly to the gearbox, with a large rubber boot | Drive shafts with two joints each run from the gearbox to the wheels |
| Vehicles | Beetle sedan and convertible 1200, 1300, 1500, 1600 (standard), Bus T1 (with reduction boxes), Karmann Ghia in European specification | Beetle Automatic from model year 1968, Beetle 1302 and 1303, Karmann Ghia in US specification, Bus T2 from 8/1967, Bus T3 |
| Typical wear parts | Axle boots swing axle, Axle shaft bushings (slide blocks), Gearbox seal kit swing axle | CV boots IRS (set of 4), CV joint, Drive shaft, Gearbox seal kit IRS |
A swing axle gearbox and an IRS gearbox cannot simply be swapped for each other – rear axle, mounts and drive shafts are different.
Gearbox code letters VW Beetle and Karmann Ghia
| Code | Displacement | Version / period | Final drive ratio |
|---|---|---|---|
| AA | 1200 cc | Beetle 1200 | 4.375 |
| AB | 1300 cc | up to 8/1970 | 4.375 |
| AC | 1500 cc | from 8/1970 also some 1300s | 4.125 |
| AH | 1500/1600 cc | IRS: 1500 from 8/1968, 1600 8/1969 to 8/1972 | 4.125 |
| AK | 1500/1600 cc | Thing (Type 181) | 3.875 |
| AM | 1300 cc | sedan and convertible from 8/1970 | 4.375 |
| AN | 1600 cc | Karmann Ghia from 8/1970, IRS | 3.875 |
| AO | 1600 cc | Karmann Ghia from 8/1970 | 4.125 |
| AS | 1600 cc | from 1972 | 3.875 |
| AT | 1600 cc | 1303 S and convertible from 1972 | 3.875 |
A selection of the most common gearboxes; there were also versions with limited-slip differential and semi-automatic. The final drive ratio tells you how many times the input turns for one turn of the wheel – the lower the value, the "taller" the gearing.
Gearbox in the VW Bus T2: 002 or 091?
The Bus T2 has two gearbox generations. How to tell them apart:
| Feature | Gearbox 002 | Gearbox 091 |
|---|---|---|
| Original fitment in the Bus T2 | up to 7/1975 | from 8/1975 |
| Code letters | CA to CN | CP to CX |
| Casting number on the case starts with | 002 | 091 |
| Bearing cover (2nd case section from the front) | approx. 6.7 cm (2.64 in) | approx. 7.5 cm (2.95 in), about 8 mm longer |
| Drive flange diameter | 42 mm | 45 mm |
| Largest clutch | 215 mm (228 mm only with machining of the bell housing) | up to 228 mm |
| Starter | standard starter as on the Beetle | special starter with longer pinion |
| Seal kit | Gearbox seal kit 002 | Gearbox seal kit 091 |
Both exist with a short input shaft (1600) and a long input shaft (1700 to 2000). From 8/1970 the bell housing has threads for the release bearing guide sleeve, from 8/1971 lugs on top for mounting to the body. Because bell housings and shafts were often swapped, there are many mixed versions – best check every component.
Gearbox code letters VW Bus T2
| Code | Engine | Period | Final drive ratio |
|---|---|---|---|
| CA, CC | 1600 | 1968–1971 | 5.375 |
| CB, CD | 1600 | 1968–1971 | 5.857 (mountain gearbox) |
| CE | 1600 | 1972–1975 | 5.428 |
| CF, CH | 1600 | 1972–1975 | 5.857 (mountain gearbox) |
| CG, CK, CL | 1600/1700 | 1972–1975 | 5.375 |
| CM, CN | 1800 | 1974–1975 | 4.857 |
| CP, CT | 2000 | 1976–1979 | 4.571 |
| CU, CV | 1600 | 1976–1979 | 5.428 |
| CW, CX | 1600 | 1976–1979 | 5.857 (mountain gearbox) |
The code letters describe the gearbox as delivered from the factory. On rebuilt or modified gearboxes the ratio fitted may differ.
Gearbox oil: grade, capacity and checking
| Grade | Gear oil SAE 80W-90, specification GL4 |
| Capacity Beetle and Karmann Ghia | approx. 2.5 litres (approx. 2.6 US quarts) |
| Correct oil level | up to the lower edge of the filler hole on the side of the gearbox |
Change the oil with the gearbox warm. When draining, clean the magnetic plug thoroughly – metal particles on it are a good indication of the gearbox's condition.
Tips from the workshop
- Take a photo of the gearbox number: keep it with your vehicle documents – you will have it to hand whenever you order seals or mounts.
- Check the front gearbox mount: a worn rubber mount lets the engine and gearbox move, and shifting becomes notchy. For the Beetle from model year 1973 the front gearbox mount from 8/72 fits, and there are the rear left and rear right mounts. For the Bus T2: gearbox mount T2.
- Sloppy shifting? Often it is not the gearbox but a worn shift rod coupler.
- Replace leaking boots straight away: on the swing axle gearbox oil leaks out, on the IRS the joints run dry.
Common mistakes
- Parts ordered by vehicle model year: if the gearbox has been swapped, the seal kit or mount will not fit.
- Casting number read instead of gearbox number: the raised numbers on the case are part numbers, not the identification.
- Wrong gear oil: GL5 oil is unsuitable for many old manual gearboxes – use GL4.
- Gearbox mount with the wrong number of bolts: 2-bolt and 3-bolt mounts are not interchangeable.
Frequently asked questions
Where do I find the gearbox number on a Beetle?
On a smooth pad on the right-hand underside of the gearbox case, seen from the rear. Best look from underneath with a torch and clean the area first.
Does my Beetle have a swing axle or IRS?
If the axle tubes attach directly to the gearbox, it is a swing axle – that is the case on the standard Beetle 1200 to 1600. The Beetle Automatic, the 1302 and 1303 and the Karmann Ghia in US specification have IRS with drive shafts.
How much gear oil does a Beetle need?
Approx. 2.5 litres (approx. 2.6 US quarts) of gear oil SAE 80W-90 GL4 – filled up to the lower edge of the filler hole.
Matching parts and more guides
- Gearbox, clutch & shifting VW Beetle, Gearbox & shifting VW Bus T1, Gearbox & shifting VW Bus T2 and Gearbox & shifting VW Bus T3
- Individual parts: Ring and pinion 31/9 (3.44) for AT/AS/AK/AO, Release bearing guide sleeve, Gearbox oil drain plug key
- More guides: Guided or unguided clutch, Identify your engine and Clutch adjustment – you will find all guides in our guides & tips overview.
All information without guarantee. If in doubt, send us a photo of the gearbox number – we will help you identify it. All work is carried out at your own risk.