Current filter
Paint code sticker L 96 D silbermetallic – shows the original VW paint code, ideal after restoration or a respray.
Paint code sticker L 96 E geminimetallic – shows the original VW paint code, ideal after restoration or a respray.
Paint code sticker L 96 M marathonmetallic – shows the original VW paint code, ideal after restoration or a respray.
Paint code sticker L 97 A diamantsilber-metallic – shows the original VW paint code, ideal after restoration or a respray.
Paint code sticker L 97 D coloradometallic – shows the original VW paint code, ideal after restoration or a respray.
Paint code sticker L 98 A mayametallic – shows the original VW paint code, ideal after restoration or a respray.
Paint code sticker L 99 M ischiametallic – shows the original VW paint code, ideal after restoration or a respray.
Ring compressor for pistons with 83–87 mm diameter – safely compresses the piston rings during installation.
Castrol Classic XL 20W50 in a 1-litre can – engine oil with high zinc content for your air-cooled VW.
Spray paint in VW colour L249 Dove Grey, 355 ml can – for touch-ups and small parts.
Puller for the oil pressure relief piston in the crankcase of the VW Type 1 engine.
Drilling jig for precise holes in the crankshaft and flywheel of the VW Type 1 engine.
Installer for the seal at the drive gear of the VW Type 1 engine.
Puller for the gears on the crankshaft of VW Type 1 and Type 4 engines.
Tap for repairing damaged M14 × 1.25 spark plug threads in the cylinder head.
Set of 4 thread inserts for repairing stripped spark plug threads.
Clips that hold the lifters in their bores when assembling the crankcase.
Special socket for loosening and tightening at the oil filler neck of the VW Type 1 engine.
Synchroniser for balancing twin carburettor set-ups on air-cooled VW engines.
Piston ring compressor for pistons from 88 to 94 mm – ideal for big-bore engines.
Puller for the crankshaft pulley of the VW Type 1 engine.
Adjusting wrench for setting the clutch cable at the gearbox.
Measuring plate for determining the deck height when building Type 1 engines.
Drill for finishing valve guides for 8 mm valve stems.
Engine stand for assembling and overhauling air-cooled VW engines.
Feeler gauge set with 26 blades in mm and inch – for valve clearance and contact points.
Triple square socket for the bolts of drive shafts with CV joints.
Hex socket for the filler and drain plugs of the gearbox.
Puller for the starter bush in the gearbox housing – for 12-volt vehicles.
Handy riveting tool for riveting work during repair and restoration.
{{.}}
{{{.}}}